Contact Us Sitemap Chinese Version
 
 
   
 

Other Kinds of Tools
(Taper Pipe Taps With 55o Thread Angle )
o Thread Angle


Material:H.S.S
Metric System:mm
Thread specification d Teeth per inch Pitch p Overall Length L Thread Length l Shank Diameter d1 Size of Square a
RC 1/8 28 0.907 59 15 8 6.3
RC 1/4 19 1.337 67 19 10 8
RC 3/8 75 21 12.5 10
RC 1/2 14 1.814 87 26 16 12.5
RC 3/4 96 28 20 16
RC 1" 11 2.309 109 33 25 20
RC 1-1/4 119 36 31.5 25
RC 1-1/2 125 37 35.5 28
RC 2" 140 41 40 31.5


Note:

These taps are used for tapping internal threads of taper pipe joints. Available in 55o thread angle and 1:16 taper.

There are two tap thread forms flat -topped and round -tapped. The folat -topped thread form is produced regularly and the round-topped is for special order.






                                                                  Contact us: succ@sh163.net
 

 
 

About Shme | Contact Us | Sitemap | Job Opportunity

Best viewed with either (800*600)Netscape 4.0 or IE4.0 and above